+- Smart Home Automation Forum (https://www.kincony.com/forum)
+-- Forum: Technical Support (https://www.kincony.com/forum/forumdisplay.php?fid=20)
+--- Forum: KC868-A6 (https://www.kincony.com/forum/forumdisplay.php?fid=22)
+--- Thread: kc868-a6 analog input (/showthread.php?tid=9843)
kc868-a6 analog input - Diskstain - 09-21-2026
How do you connect a thermistor to an analog input?
RE: kc868-a6 analog input - admin - 09-21-2026
if your signal is 0-5v or 4-20mA, it's ok.
RE: kc868-a6 analog input - brianallen - 11-06-2026
(09-21-2026, 11:38 PM)admin Wrote: if your signal is 0-5v or 4-20mA, it's ok.
For a thermistor, would you recommend using a voltage divider with a fixed resistor, and is there a specific resistance value or wiring diagram you suggest for the KC868-A6? Also, does the analog input need any calibration to convert the voltage reading into temperature?
RE: kc868-a6 analog input - admin - 11-06-2026
if use thermistor, suggest chose A24 or CO16 controller, that support PT100 sensor directly.