kc868-a6 analog input

[Diskstain]

How do you connect a thermistor to an analog input?

[admin]

if your signal is 0-5v or 4-20mA, it's ok.

[brianallen]

if your signal is 0-5v or 4-20mA, it's ok.

For a thermistor, would you recommend using a voltage divider with a fixed resistor, and is there a specific resistance value or wiring diagram you suggest for the KC868-A6? Also, does the analog input need any calibration to convert the voltage reading into temperature?

[admin]

if use thermistor, suggest chose A24 or CO16 controller, that support PT100 sensor directly.