"KCS" v2 firmware MQTT protocol document

[GibKat]

why can't input? use mouse click the edit section, then input. if you can't , take a video , send to whatsapp number: +86-15381188302

I can't modify the address, it seems locked (the characters are light gray and not black)

Gray is a prompt message, why don't you try clicking with the mouse and then entering the information????

I have solved. I have disconnected the IR modules before the update of firmware.

[admin]

ok

[sm4l]

Is it possible to turn an output on with timer via MQTT? E.g. turn on output1 for 1 second (then turn automatically off)?

You can use Delay option in KCS fw. 

Outputs> Type> Delay

Then you configure the delay time.

[sergiomh96]

Hola Señor, es posible enviar ordenes a dispositivos conectados mediante puerto I2C o RS485?

En caso afirmativo, que comandos hay que enviar?

Gracias!!.

[admin]

RS485 use by modbus protocol.
here is protocol document: https://www.kincony.com/forum/showthread.php?tid=2528

[sergiomh96]

RS485 use by modbus protocol.
here is protocol document: https://www.kincony.com/forum/showthread.php?tid=2528

Me he explicado mal. Quiero enviar por mqtt un valor leído por modbus, o establecer un valor por mqtt y enviar por modbus.

De igual forma con I2C

Es esto posible?

[admin]

No, KCS firmware not support that way. if you want, you can write your own arduino code.

[basilioo]

Note: This protocol document use for KinCony smart controller:
KC868-AM ASR A2 A4 A4S A6 A8 A8M A8S A16 A16S E16S A32 A32M A64 A128 AG AK AI AIO AP
Different board will have different channel of digital output, digital input , ADC, DAC, so the protocol is same , just according to the hardware resource to set channel number.

is there any mqtt command to reboot kc868-a16 board?

[admin]

sorry, no this command.