1 hour ago
Hello KinCony team,
I am using a KC868-A8v3 with firmware KCS v3.27.4 connected to a Loxone Miniserver via UDP.
What already works:
• Controlling relays from Loxone (RELAY-SET-255,1,1\n) works fine.
• Receiving relay feedback on UDP port 23456 (RELAY-SET-255,1,\h,OK) works fine.
• Both DS18B20 sensors are properly configured in KCS (Sensor ID 1 on GPIO 40, Sensor ID 2 on GPIO 13) and show valid temperatures in the KCS web interface.
My problem with the DS18B20 sensors in Loxone:
1. KCS does not automatically send DS18B20 temperature updates to Loxone via the UDP client.
2. When I poll the sensor from Loxone by sending RELAY-GET_SENSOR-255,1\n to UDP port 4196, the KC868-A8v3 replies in the Loxone UDP Monitor with:
RELAY-GET_SENSOR-255,1,28,-100,OK
3. However, Loxone does not parse the temperature value into the Virtual UDP Input command. I have already tried the following command recognition strings (with "Use as digital input" unchecked):
• RELAY-GET_SENSOR-255,1,\v,-100,OK
• RELAY-GET_SENSOR-255,1,\v,\i,OK
• RELAY-GET_SENSOR-255,1,\v,
My questions:
1. What is the exact Command Recognition string required in Loxone Config to parse RELAY-GET_SENSOR-255,1,\v,?
2. Can KCS v3.27.4 send DS18B20 temperature changes automatically to the Loxone UDP client (port 23456) if I set a Threshold value > 0, or do sensors always have to be polled via RELAY-GET_SENSOR-255,x?
Thank you very much for your help!
I am using a KC868-A8v3 with firmware KCS v3.27.4 connected to a Loxone Miniserver via UDP.
What already works:
• Controlling relays from Loxone (RELAY-SET-255,1,1\n) works fine.
• Receiving relay feedback on UDP port 23456 (RELAY-SET-255,1,\h,OK) works fine.
• Both DS18B20 sensors are properly configured in KCS (Sensor ID 1 on GPIO 40, Sensor ID 2 on GPIO 13) and show valid temperatures in the KCS web interface.
My problem with the DS18B20 sensors in Loxone:
1. KCS does not automatically send DS18B20 temperature updates to Loxone via the UDP client.
2. When I poll the sensor from Loxone by sending RELAY-GET_SENSOR-255,1\n to UDP port 4196, the KC868-A8v3 replies in the Loxone UDP Monitor with:
RELAY-GET_SENSOR-255,1,28,-100,OK
3. However, Loxone does not parse the temperature value into the Virtual UDP Input command. I have already tried the following command recognition strings (with "Use as digital input" unchecked):
• RELAY-GET_SENSOR-255,1,\v,-100,OK
• RELAY-GET_SENSOR-255,1,\v,\i,OK
• RELAY-GET_SENSOR-255,1,\v,
My questions:
1. What is the exact Command Recognition string required in Loxone Config to parse RELAY-GET_SENSOR-255,1,\v,?
2. Can KCS v3.27.4 send DS18B20 temperature changes automatically to the Loxone UDP client (port 23456) if I set a Threshold value > 0, or do sensors always have to be polled via RELAY-GET_SENSOR-255,x?
Thank you very much for your help!

