Set ON/OFF one channel of digital output
|
Set ON/OFF one channel of digital output
|
02-16-2024, 08:53 AM
(02-15-2024, 01:07 AM)admin Wrote: digital input short with GND means triggered. if your board use by DC24v power supply. also INPUT short with GND is triggered, it's dry contact. If I reverse the signal level in the settings, I basically get what I need.. as the trigger is OFF when I connect it to my power supply, but when I turn on 24V, it reads high as expected. Is it safe to run it that way? The 24V on the input will not damage anything? |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Set ON/OFF one channel of digital output - by kloper360 - 02-14-2024, 11:46 AM
RE: Set ON/OFF one channel of digital output - by kloper360 - 02-14-2024, 06:41 PM
RE: Set ON/OFF one channel of digital output - by admin - 02-15-2024, 01:07 AM
RE: Set ON/OFF one channel of digital output - by kloper360 - 02-16-2024, 08:53 AM
RE: Set ON/OFF one channel of digital output - by admin - 02-16-2024, 11:21 AM
RE: Set ON/OFF one channel of digital output - by kloper360 - 02-16-2024, 11:59 AM
RE: Set ON/OFF one channel of digital output - by admin - 02-16-2024, 12:07 PM
|
| Users browsing this thread: |
| 1 Guest(s) |
