KC868-A16 wiring diagram

[admin]

yes, you are right, A16 support use by DC24v power supply. DC12v is one of case.

[kloper360]

yes, you are right, A16 support use by DC24v power supply. DC12v is one of case.

Perfect!!

Thank you very much for the fast reply!!

[admin]

you are welcome.

[Brouk]

For the logical input, I need to use the variant: DC +8-12V is logical "1".
How should I connect the +?V DC voltage input to the A16 input? Can I (must) use the same +12VDC source as the A16 module power supply? Where do I connect the GND on the input terminals?

[admin]

use by DC12-24v power supply for KC868-A16
digital input can use dry contact signal or DC12-24V.

[Brouk]

OK, so I am going use one 24V DC source to power A16 and to (from the same source) +24V to the logic input terminals.

[admin]

sure , no problem.

[Brouk]

I tested both variants on Digital Input: 
1/ use dry contact signal [input is connected to GND terminal by button] => logical 1... that's OK. 
2/ use of DC +12 [the input is connected by a button to the +12V source of the A16 module] => no change in the input is shown in the Monitor screen. ..here is the error. 

according to your description, it should respond to +12V DC (or +24V). 
where is the problem? please, send me the wiring diagram for variant 2/.

[admin]

0v = trigger
12v or 24v = NOT trigger

[Brouk]

I don't understand your answer.

In the description of the device A16, you have the input DC 8-12V is logical "1". I bought the A16 mainly because of this information. I have +12V DC voltage outputs from other devices that signal logic "1" and I need to measure them and convert them to HomeAssistant.