Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
KC868-D8
#1
Hello
I have a question about KC868-D8 in server mode
Is it correct that I don't receive command if I close any digital input on the board?
I think that a client connected to the KC868-D8 should be receive a command (or string) about output variation
thank you
Reply
#2
if KC868-D8 work in "MQTT", the digital input close, then KC868-D8 should be receive a command (or string) about output variation by payload.
if KC868-D8 work in "TCP Server", will not auto update when digital input close.
Reply
#3
(05-06-2022, 12:50 AM)admin Wrote: if KC868-D8 work in "MQTT", the digital input close, then KC868-D8 should be receive a command (or string) about output variation by payload.
if KC868-D8 work in "TCP Server", will not auto update when digital input close.

I think is not correct but thank you in any case
Reply
#4
need read state manual send command.
Reply
#5
(05-07-2022, 12:35 AM)admin Wrote: need read state manual send command.

sorry for my late reply
I can't ask the output state continuously, It should be the server that send to client every status chang of analog output like for other server (CLOB,H32B...etc..) otherwise I can't monitoring the system
thank you
Reply
#6
do you using MQTT with KC868-D8?
Reply
#7
(08-03-2022, 03:09 PM)admin Wrote: do you using MQTT with KC868-D8?

no, KC868-D8 is in server mode and I use it with tcp command
Reply
#8
you can send read state command for every 500ms. D8 when dimmer brightness changed , only auto feedback to MQTT.
Reply
#9
(08-03-2022, 10:56 PM)admin Wrote: you can send read state command for every 500ms. D8 when dimmer brightness changed , only auto feedback to MQTT.

if no way to get auto report no problem, but I continue to don't understand the why others device in server mode works correctly and this device no
thank you very much for you support
Reply
#10
because we mainly update it for MQTT.
Reply


Forum Jump:


Users browsing this thread: