08-26-2022, 07:37 PM
(This post was last modified: 08-27-2022, 12:11 AM by ahmedk4444@yahoo.com.)
I can't access yaml files
I installed drivers and Rpiboot, with jumper to the right after i removed my usb memory stick.
Now the home assistant is working on local and internet using duckdns but i lost communication of A16 and H32B controllers also all configuration that we made and most of them pop up error and request to go back.
I can't control now A16, H32B as well as the H32B terminsl switch board through kincony 2 remote controls
It is important to inform us how to backup the data and when system crash or home assistant crash how can you revert back all configuration that we made other wise it is waist of time also i can't access the usb memory stick and not able to move the data to it again.
Due to criticality now the H32B is connected to the load and can't be control neither apps ( home assistant nor remote control!!) The only way to control to do a wire jumper and short on the terminal switch board to switch on/ off current lighting load connected , which is really bad and uncontrollable
Please help me by remote sharing to see if we need to run everything again ?or is any way to revert back the last good configuration.?
Thank you
I installed drivers and Rpiboot, with jumper to the right after i removed my usb memory stick.
Now the home assistant is working on local and internet using duckdns but i lost communication of A16 and H32B controllers also all configuration that we made and most of them pop up error and request to go back.
I can't control now A16, H32B as well as the H32B terminsl switch board through kincony 2 remote controls
It is important to inform us how to backup the data and when system crash or home assistant crash how can you revert back all configuration that we made other wise it is waist of time also i can't access the usb memory stick and not able to move the data to it again.
Due to criticality now the H32B is connected to the load and can't be control neither apps ( home assistant nor remote control!!) The only way to control to do a wire jumper and short on the terminal switch board to switch on/ off current lighting load connected , which is really bad and uncontrollable
Please help me by remote sharing to see if we need to run everything again ?or is any way to revert back the last good configuration.?
Thank you