how to use "KCS" firmware for KinCony ESP32 board

[admin]

Note: This protocol document use for KinCony ESP32 smart controller:
KC868-A4 KC868-A6  KC868-A8 KC868-A8S KC868-A16 KC868-E16S KC868-A32 KC868-A64 KC868-A128 smart controller
Different board will have different channel of digital output, digital input , ADC, DAC, so the protocol is same , just according to the hardware resource to set channel number.

"KCS" onliine guide: https://www.kincony.com/kcs-firmware-esp32-board.html


  KCS_user_guide_v1.0.pdf (Size: 901.95 KB / Downloads: 559)

[Elvi Bualoy]

Hi Admin and All Member,

Im not sure if anyone have the same issue as I have. Im using a KC868-E16S I manage to upload the firmware and open the webpage. What I notice  is every time I go to protocol-->general--> and enable the MQTT, Http server, TCP server, UDP Server and RS485 and then SAVE every time it restart or reset, I cannot anymore connect to the web page and even its wifi. Appreciate if you could check on this one. Thank You.

[admin]

if not used protocol, disable it. after you download, remove your USB-C cable is better.