KC 868 Server

[ezra@riverviewwoodproducts.com]

Hello,

 KC 868 Server running Home Assistant. 
 
 
>Can Anyone help me figure out what I need to do so that my Analog sensors update by themselves on my home assistant dashboard Gauge Card.
 
 
 
>It updates only when I turn on an off a output signal. But I want it to just update the sensor by itself every 5 seconds or so. I have a 4-20 ma water level sensor connected to it.

can this be done by a way of pining the server somehow? i haven't had luck with that either.

[admin]

KC868-Server no analog input ports. if you want use 4-20mA in home assistant, you can add any kincony board with 4-20mA sensor port, then integrate to home assistant by ESPHome.