Users browsing this forum: 1 Guest(s)

Mark this forum read KC868-A series and Uair Smart Controller
Thread / Author			Replies [asc]	Views	Rating	Last Post
		Debuter avec KC868-A16 v1.66 jflala, 01-09-2026, 11:27 AM	3	276	0 Vote(s) - 0 out of 5 in Average	01-10-2026, 09:05 AM Last Post: admin
		Board output not responding to input commands Elgatoguiri, 01-03-2026, 12:02 PM	3	312	0 Vote(s) - 0 out of 5 in Average	01-04-2026, 07:29 AM Last Post: admin
		Relay board wiring error? Elgatoguiri, 01-22-2026, 02:58 PM	3	294	0 Vote(s) - 0 out of 5 in Average	01-31-2026, 02:21 AM Last Post: admin
		Kincony A-128 – Digital Output LEDs glowing when OFF + module freezes when switching krzemodam2, 02-10-2026, 09:57 AM	3	170	0 Vote(s) - 0 out of 5 in Average	02-11-2026, 03:28 AM Last Post: admin
		Lesson20- how to use PCF8574 IIC extend GPIO for ESP32 input ports admin, 10-10-2021, 01:07 AM	2	3,718	0 Vote(s) - 0 out of 5 in Average	08-17-2024, 01:43 AM Last Post: admin
		Lesson27- KC868-A8 integrate home assistant by ESPHome demo and http command admin, 11-02-2021, 12:38 AM	2	6,705	0 Vote(s) - 0 out of 5 in Average	07-29-2022, 03:10 AM Last Post: admin
		how to change IIC SDA SCL pin in arduino config file admin, 11-26-2022, 12:58 AM	2	3,958	0 Vote(s) - 0 out of 5 in Average	11-28-2022, 11:19 AM Last Post: admin
		how to config 0-5v/4-20mA ADC sensor for ESPHome admin, 10-27-2023, 02:43 AM	2	2,787	0 Vote(s) - 0 out of 5 in Average	02-03-2025, 05:08 AM Last Post: admin
		Retrofitting an RTC battery on the I2C bus in the KC858-A-8 V1.6 panel HA7CQ, 03-16-2024, 09:10 PM	2	1,181	0 Vote(s) - 0 out of 5 in Average	03-17-2024, 12:47 AM Last Post: HA7CQ
		Notes on using the DHT22 twostar, 04-14-2025, 12:38 PM	2	972	0 Vote(s) - 0 out of 5 in Average	07-05-2025, 11:01 AM Last Post: twostar
		KC868-AI and pulse_counter scorx, 05-03-2025, 08:48 PM	2	875	0 Vote(s) - 0 out of 5 in Average	05-04-2025, 08:50 AM Last Post: scorx
		Transmit calculated ADC values via MQTT instead of raw values korl, 03-22-2025, 06:26 AM	2	1,002	0 Vote(s) - 0 out of 5 in Average	03-23-2025, 08:18 PM Last Post: korl
		KC868-a6-v1.3sp + Pulse counter boneless, 05-17-2025, 04:33 PM	2	1,061	0 Vote(s) - 0 out of 5 in Average	05-19-2025, 01:30 PM Last Post: boneless
		KC868-a6-v1.3sp + 0.5V Analog Input boneless, 05-23-2025, 01:22 PM	2	1,065	0 Vote(s) - 0 out of 5 in Average	05-24-2025, 12:45 PM Last Post: boneless
		KC868-A32 and EspEasy firmware voyo, 05-24-2025, 12:36 AM	2	1,051	0 Vote(s) - 0 out of 5 in Average	08-14-2025, 03:42 PM Last Post: coplime
		UART2 bd39, 07-21-2025, 04:22 PM	2	706	0 Vote(s) - 0 out of 5 in Average	07-21-2025, 09:21 PM Last Post: admin
		KC868-V16 and 6-terminal PIR Wiring tasman, 09-18-2025, 06:00 AM	2	736	0 Vote(s) - 0 out of 5 in Average	09-27-2025, 06:01 AM Last Post: tasman
		Lesson11- Apple HomeKit control relay on ESP32 by Arduino IDE admin, 06-19-2021, 08:25 AM	1	4,631	0 Vote(s) - 0 out of 5 in Average	02-08-2022, 05:05 AM Last Post: drfungyy
		KC868-A Pins to HomeSpan HomeKit glock4101, 12-31-2021, 10:43 AM	1	3,590	0 Vote(s) - 0 out of 5 in Average	01-01-2022, 02:40 AM Last Post: admin
		TWAI (CANBUS) interface on KC868 board Pierzogad, 06-16-2022, 10:32 AM	1	3,025	0 Vote(s) - 0 out of 5 in Average	06-16-2022, 10:58 AM Last Post: admin
		KC868-A16 Ethernet ESP32 davesmithr1, 09-08-2022, 09:23 AM	1	3,131	0 Vote(s) - 0 out of 5 in Average	09-08-2022, 11:03 AM Last Post: admin
		STM32 Source Code h.berkay, 09-14-2022, 11:31 AM	1	3,139	0 Vote(s) - 0 out of 5 in Average	09-14-2022, 11:40 AM Last Post: admin
		KC868-A6 Relays Senapsys, 10-22-2022, 04:26 AM	1	3,310	0 Vote(s) - 0 out of 5 in Average	10-22-2022, 12:08 PM Last Post: admin
		KC868 A8 - Help In Program mfjunior96, 02-28-2023, 01:24 AM	1	2,983	0 Vote(s) - 0 out of 5 in Average	02-28-2023, 01:30 AM Last Post: admin
		KC868-A32 Question miguelflpp, 04-12-2023, 09:47 AM	1	2,441	0 Vote(s) - 0 out of 5 in Average	04-12-2023, 10:02 AM Last Post: admin
		K868-A32 Domoticz lori72, 04-22-2023, 11:32 AM	1	2,597	0 Vote(s) - 0 out of 5 in Average	04-22-2023, 11:47 AM Last Post: admin
		Rebooting Core 0 panic'ed (LoadProhibited). Exception was unhandled. rha, 05-11-2023, 12:04 PM	1	2,280	0 Vote(s) - 0 out of 5 in Average	05-11-2023, 12:06 PM Last Post: admin
		Does your device support the frequency measurement mode at the Digital Input pin? Bogdan107, 05-24-2023, 07:56 PM	1	2,238	0 Vote(s) - 0 out of 5 in Average	05-25-2023, 12:23 AM Last Post: admin
		KC868-Uair Marzuqi, 06-07-2023, 06:37 AM	1	2,195	0 Vote(s) - 0 out of 5 in Average	06-08-2023, 12:54 AM Last Post: admin
		KinCony KC868-AP Modbus using in Esphome not working nikhuge, 06-21-2023, 09:59 PM	1	2,210	0 Vote(s) - 0 out of 5 in Average	06-22-2023, 12:07 AM Last Post: admin
		Using two PCF8574s for DI and DO mafckz, 06-25-2023, 12:23 PM	1	2,414	0 Vote(s) - 0 out of 5 in Average	06-25-2023, 12:42 PM Last Post: admin
		KC868-A16 NC outputs Karle, 08-26-2023, 09:53 AM	1	2,183	0 Vote(s) - 0 out of 5 in Average	08-26-2023, 11:44 AM Last Post: admin
		My questions about KC868-H32B PRO? chelios59, 09-28-2023, 04:35 PM	1	1,538	0 Vote(s) - 0 out of 5 in Average	09-29-2023, 12:04 AM Last Post: admin
		KC868-A8 max6675 eXtazy, 11-24-2023, 07:54 PM	1	1,297	0 Vote(s) - 0 out of 5 in Average	11-25-2023, 01:45 AM Last Post: admin
		KC868-A32M vs KC868-A16 charlesrg, 01-01-2024, 02:51 AM	1	1,209	0 Vote(s) - 0 out of 5 in Average	01-01-2024, 05:41 AM Last Post: admin
		ws2812 led digital strip or similar ndev, 02-01-2024, 09:53 AM	1	884	0 Vote(s) - 0 out of 5 in Average	02-01-2024, 12:02 PM Last Post: admin
		KC868-A8 Useless Opto on input? bluluiss, 02-04-2024, 08:43 AM	1	1,052	0 Vote(s) - 0 out of 5 in Average	02-04-2024, 01:00 PM Last Post: admin
		KC868-A2 SIM7600 Carl, 02-11-2024, 05:04 PM	1	951	0 Vote(s) - 0 out of 5 in Average	02-12-2024, 01:53 PM Last Post: admin
		Two IFTT on same Input philippe, 03-28-2024, 08:07 AM	1	634	0 Vote(s) - 0 out of 5 in Average	03-28-2024, 10:01 AM Last Post: admin
		ZP13 Smoke Gas Sensor Module aseksas, 02-26-2024, 09:01 PM	1	850	0 Vote(s) - 0 out of 5 in Average	02-26-2024, 10:28 PM Last Post: admin
		KC868-A* Default Firmware v1rtus, 03-12-2024, 05:24 PM	1	1,023	0 Vote(s) - 0 out of 5 in Average	03-12-2024, 11:34 PM Last Post: admin
		KC-868-A8 analog output 0-10v robbansson, 04-17-2024, 11:51 AM	1	761	0 Vote(s) - 0 out of 5 in Average	04-17-2024, 10:17 PM Last Post: admin
		KC868-HAv2 ahmedwizza1, 04-17-2024, 02:31 PM	1	651	0 Vote(s) - 0 out of 5 in Average	04-17-2024, 10:21 PM Last Post: admin
		Smoke Sensor Connected to KC868-AI fdcemb5, 04-28-2024, 11:19 AM	1	604	0 Vote(s) - 0 out of 5 in Average	04-28-2024, 11:43 AM Last Post: admin
		output turns off automaticly deibar, 05-06-2024, 06:34 PM	1	773	0 Vote(s) - 0 out of 5 in Average	05-06-2024, 11:55 PM Last Post: admin
		KC868-A8 - Possible to use A1 and A2 as standard inputs? deanfourie, 05-21-2024, 02:20 AM	1	718	0 Vote(s) - 0 out of 5 in Average	05-21-2024, 06:24 AM Last Post: admin
		KC868-AI - from Alarm panel Bestgear, 06-15-2024, 05:55 PM	1	700	0 Vote(s) - 0 out of 5 in Average	06-15-2024, 10:35 PM Last Post: admin
		Tuto for NOOBS Denis S., 06-23-2024, 02:05 PM	1	763	0 Vote(s) - 0 out of 5 in Average	07-12-2024, 04:38 AM Last Post: admin
		KC868-A8S v2 manufacture issue? print issue? Tasmota issue? TerryAU, 07-18-2024, 05:06 AM	1	686	0 Vote(s) - 0 out of 5 in Average	07-18-2024, 05:37 AM Last Post: admin
		KC868-AI TCP COMUNICATION PROTOCOL Dm81, 07-21-2024, 07:03 AM	1	823	0 Vote(s) - 0 out of 5 in Average	07-21-2024, 08:15 AM Last Post: admin
Sort by: Subject Sort by: Last Post Sort by: Author Sort by: Creation Time Sort by: Rating Sort by: Replies Sort by: Views Order: Ascending Order: Descending From: Today From: 5 Days Ago From: 10 Days Ago From: 20 Days Ago From: 50 Days Ago From: 75 Days Ago From: 100 Days Ago From: The Last Year From: The Beginning